Thermostat / Controller BTC70 for Electric Underfloor Heating
Ease of use and installation are the main advantages of this thermostat. The thermostat maintains the desired floor temperature and significantly reduces heating costs. The thermostat BTC70 has been developed for electrical underfloor heating or other electrical heating elements. The thermostat has a control range of + 5 ° C to + 40 ° C. When the heater is on, the LED light glows red. When the desired temperature is reached, the heating stops for as long as the temperature does not fall 0.5 degrees below the set temperature, then the heating starts again until the desired temperature is reached.
Max/Min temperature setting The locking mechanism for maximum / minimum temperature limitation is located under the rotary knob (open the housing for this). The temperature selection can be set, for example, from 20 ° C to 25 ° C. The red ring shows the maximum temperature and the green ring the minimum temperature. Installation of the floor temperature sensor The floor temperature sensor should be in the mounting pipe in the floor. The sensor cable can be extended up to 50m with a power cable with a cross-section of 0.5mm. Placement of the thermostat The thermostat should be mounted on the wall in a free place with adequate air circulation. It must not be exposed to any other heat sources, such as direct sunlight or drafts from windows and doors.
|power consumption:||5 W|
|setting range:||5°- 40°C|
|housing material:||anti-flammable PC|
|max. load:||16 A / 230 V / AC|
|operating temperature:||-5°C bis + 50°C|